通信電纜 網絡設備 無線通信 云計算|大數據 顯示設備 存儲設備 網絡輔助設備 信號傳輸處理 多媒體設備 廣播系統 智慧城市管理系統 其它智慧基建產品
深圳市連訊達電子技術開發有限公司
梅凱Megger DET4T2系列DET4TD2|DET4TR2|DET4TC2|DET4TCR2絕緣電阻測試儀
梅凱Megger MIT300|MIT310|MIT310A|MIT320| MIT330絕緣電阻測試儀
梅凱Megger MIT400/2|MIT410/2|MIT420/2 |MIT430/2 四類絕緣測試儀
梅凱Megger MIT481/2 和 MIT485/2絕緣電阻測試儀
梅凱Megger MIT2500高壓手持式絕緣和連續性測試儀
梅凱Megger DLRO100E,DLRO100X及DLRO100H高度便攜微歐表100A
梅凱Megger MIT415/2 和 MIT417/2絕緣電阻測試儀
梅凱Megger MIT200|MIT210|MIT220|MIT230絕緣電阻測試儀
梅凱Megger MOM600A,MOM200A微歐計(回路電阻計)
梅凱Megger DET2/3高分辨率接地測試儀DET2/3RC
梅凱Megger DLRO10HDX低電阻微歐計DLRO10HD
梅凱Megger DET14C 和 DET24C接地電阻測試儀
梅凱Megger S1-1568直流絕緣電阻測試儀 15 kV
梅凱Megger S1-1068直流絕緣電阻測試儀S11068
EXFO光功率計PX1,PX1-PRO,PX1-S-PRO,PX1-H-PRO,PX1-S-PRO,PX1-H-PRO
EXFO FPM-600光功率計FPM-602 FPM-602X
EXFO FTBx-720C LAN/WAN接入網OTDR光時域反射儀
EXFO FTBx-730C PON FTTx/MDU OTDR光時域測試儀
EXFO FTBx-735C城域網/PON FTTx/MDU OTDR
EXFO MaxTester 720C - 接入網OTDR光時域反射儀
EXFO MaxTester 730C PON/城域網OTDR光時域反射儀
EXFO ELS-50光源ELS-50-23BL單模ELS-50-12C多模光源
EXFO FPM-300光功率計FPM-302,FPM-302X
EXFO FLS-300單多模光源FLS-300-12D,FLS-300-235BL
NetAlly TEST-ACC吞吐測試選件(iPerf服務器)TEST-ACC-5PK/TEST-ACC-10PK
NetAlly Aircheck G2無線網絡測試儀AIRCHECKG2-TA-KT
NetAlly LinkRunner 10G網絡測試儀LR10G-100|LR10G-100-KIT|EXG-LR10G-KIT
NetAlly LRAT-2000/LRAT-1000網絡測試儀LinkRunner AT(LRAT-2000-KIT)
NetAlly LinkRunner G2智能網絡測試儀LR-G2,LR-G2-KIT,LR-G2-ACKG2-CBO
NetAlly AirMagnet Wi-Fi Analyzer PRO無線分析儀(AM/A1150)
NetAlly EXG-200|EXG-200-KIT網絡測試儀EtherScope nXG
NetAlly LSPRNTR-300網絡測試儀LinkSprinter
NetAlly AirMagnet Survey PRO無線勘測儀WLAN分析工具(AM/A4018)
NetAlly AirMagnet Spectrum XT頻譜分析儀(AM/B4070|AM/A4040)
NetAlly 1TG2-3000/1TG2-1500網絡性能測試儀1T10G-1000
NetAlly EXG-200-KIT|EXG-200-KIT-2PK|EXG-200-LRG2-KIT|EXG-LR10G-KIT網絡測試儀EtherScope nXG
NetAlly AirCheck G3 Pro 第三代無線網絡測試分析儀
NETSCOUT 1TG2-3000-2PAK|1TG2-1500-2PAK|1T10G-1000-2PAK|網絡測試助手Onetouch AT G2
NETSCOUT LRAT-1000|LRAT-2000網絡測試儀LinkRunner AT
NETSCOUT AirMagnet Survey無線測試儀
NETSCOUT AirMagnet Spectrum XT無線頻譜分析儀
NETSCOUT LSPRNTR-300 網絡測試儀LinkSprinter
NETSCOUT AirMagnet WiFi Analyzer PRO無線網絡測試儀
NetAlly(NetScout) 1TG2-1500-LRAT2/1TG2-3000-LRAT2網絡測試儀
NETSCOUT 1TG2-1500|1TG2-3000|1T10G-1000網絡測試儀
NETSCOUT LR-G2|LR-G2-KIT智能網絡測試儀LinkRunner G2|LR-G2-LS-KIT報價 圖片 參數
暫無信息 |
閱讀:3發布時間:2024-12-27
Port or cabling short Autotest not available - CableIQ
You may receive the following message:
The Autotest may not run if the tester is connected to a data port, detects voltage or a short on the cabling. If any of these three instances occur, you may see the screen above.
Rotate the dial to DISCOVER. The CableIQ should be able to tell you why it cannot run an Autotest. In this example, the CableIQ was connected to an active port:
Here we see that the port the CableIQ is connected to is capable for 10BASE-T, 100BASE-T is Full Duplex mode and is 41.5 m from the CableIQ.
What if the warning "Port or Cabling short Autotest not available" occurs while connecting the Cable IQ over a cable to the CIQ-WM far end adapter?
This is an indication that the far end adapter may need to be replaced.
You can validate the RJ45 port on the Cable IQ by leaving the cable attached and turn the dial to DISCOVER. If the RJ45 port is good, you should be able to press F1 and see the pair lengths on the attached cable. It is normal to see a small variance on pair lengths between the pairs, as the twist rates are different. If you see 0 length for a pair, it indicates a problem with the RJ45 port on the Cable IQ; contact the Service Center for repair.
If you have any of the additional office identifiers for Cable IQ (CIQ-IDK24 or CIQ-IDK57), try using one at the far end of the cable with an RJ45 coupling and see it it works to run the Autotest.
Otherwise, replace your CIQ-WM far end adapter.
智慧城市網 設計制作,未經允許翻錄必究 .? ? ?
請輸入賬號
請輸入密碼
請輸驗證碼
請輸入你感興趣的產品
請簡單描述您的需求
請選擇省份